Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two br342 worked in bridge mode, and connected two LAN together( there are two br342 with firmware version 8.80 and two yagi 1949 antnna, the distance is about 1.5 Km). Formerly they all worked fine enen in bad weather.But recently the two ...
Aug 6, 2003, 7:05pm PST I have a 3640 fastethernet problem, the interface always appeared to be disabled, when I enter 'no shutdown' at the interface configuration mode, it can not work. Below is some of the command display result I entered. Hope som...
I have a 3640 fastethernet problem, the interface always appeared to be disabled, when I enter 'no shutdown' at the interface configuration mode, it can not work. Below is some of the command display result I entered. Hope someone can help me to re...
Thank you scheikhnajib, further more I found that actually the access-list 101 does not make any sense,all the traffic can access to my outside interface 72.0.207.228. Also when I telnet to my outside interface from internet, I successfully telnet to...
Thank you for your message! I have tried the Antenna alignment test, it looks like a bad signal.My Channel was set to auto. And the signal was very good one month ago, we have used it for about two years. During these time the connection never discon...
Dear ARIEL CESAR MANOSCA: Thank you for your help, as you described I re-seated the network module. The problem is now solved! Thanks again for your help! Guozhijun
