Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am using the configurations given in the following linkhttp://www.cisco.com/en/US/partner/netsol/ns110/ns170/ns171/ns27/networking_solutions_white_paper09186a008018914d.shtmlBut i am not able to see the IPSec SAs in the routers.The output of sh ...
hey, Cisco routers now come with SDM (Security Device Manager), using which you can configure the routers.You can configure GRE over IPSec using this tool.Please go through www.cisco.com/go/sdm-Deepu
For a single ip address you are using a pool. I think this is not needed. You could giveip nat inside source list 1 interface serial 1 overload. This should do the natting to all the private ip addresses with different port numbers.-Deepu
This is nothing to do with the service module commands as the default configuration should work.When you are giving a mannual loopback on your WIC its looping there itself and hence the interface comes up.Did you try giving loopback from your end to ...
Try giving the command Squeeze flash. Else, copy the working image to ur tftp server and then erase the flash by giving erase flash. This will erase the flash files. Dont reboot the router. Now the flash doesnt contain any files. Try uploading the im...
