Other Network Architecture Subjects

Quick question. If I have two switches connected to each other and one is vlan1 and the other is vlan2 and I am seeing the error native vlan mismatch, how can the two switches talk to each other. If the packet has been assighned vlan 2 on one switch ...

Hi, I could not boot from flash after installing a new flash. Errors as shown in the follwing:switch:switch: dir flash:Directory of flash:/3 -rwx 1809152 <date> c2900xl-c3h2s-mz.120-5.WC10.bin4 -rwx 324 <date> ...

I'm looking for an analyzer for 10/100/1000M,10giga ethernet,iSCSI,1,2,4,10G fibre.What kind of analyzer is most popular and good(easy to use etc) for above ?Please let me know the product nama or url.

Hi,can somebody tell me what the difference is between these auth modes ? When do I need which mode and how do I need to configure this ?

How can I perform password recovery for a Cisco 2924XL switch?Thank you

How and where does secondry address in ethernet comes to use and what is the max secondary route I can add?

how can i get all serial no of 7600 series router specifically of FAN Tray,GBIC modules etcShow inventory command does not show the above serial no.s.

my cisco 1720 router has died on me and i'm looking to replace it. the key features i need are NAT with port redirection (forward an outside port to a different inside port, e.g. outside port X to inside port Y) and traffic-shaping. I need to be ab...

Here's the problem: Every few hours or so, we stop receiving packets on either one of two Serial interfaces on our Cisco 2610 router. However, the interface line protocol stays "up" the whole time. Reloading the router fixes the problem temporaril...

I have disscussion with my co-worker to decide what we should use to control and modify routing information that is exchanged between routing domains. both neighbor prefix-list and neigbor route-map serve the the purpose.and both could work together ...

One can use the SAA feature with static routes of different weights to roll the routing on a router to another next-hop.I need to know if using SAA and tracking an IP on the Internet, if one can bring down an interface (like its line protocol).

One can use the SAA feature with static routes of different weights to roll the routing on a router to another next-hop.I need to know if using SAA and tracking an IP on the Internet, if one can bring down an interface (like its line protocol).

I have a router in a customer site that accesses our servers. I want to statically NAT the customers source address so our firewall will allow it. Will NAT work correctly using the ip address of the serial inteface?ip nat outside source static 66.162...

Can someone tell me what happens if in my Internet routers I have 2 default route? does it affect my traffic and if some one can give me name of the tool from which can analysze which user/users are doing download or FTP on internet link and using c...

Is it possible to load share accross Sub interfaces (DLCIs)that are on the same serial interface?