04-18-2003 05:33 PM - edited 03-02-2019 06:45 AM
We have a 4503 configured as a core switch. Our parent company had installed a T1 for intanet back to the HQ. At the time we were running a switched network, no gateways only proxy to the internet. So we decided at the time is was worth putting it on a a NATed Win2k box. Things have changed since then with the 4503. We are starting to segment out the lan. Heres where I run into problems. The 2600 router is owned and managed by our parent company.
IP of router is 10.177.0.2 /24
IP of g3/24 on the 4503 is 10.177.0.3 /24
IP of VLAN1 on 4503 is 10.0.30.31/22
I have configured the switch as this.
int g3/24
no switch port
ip address 10.177.0.3 255.255.255.0
descerption uplink to HQ
speed auto
int vlan1
ip address 10.0.30.31 255.255.240.0
ip route 10.46.0.0 255.255.255.0 10.177.0.2
(this is the intranet segemnt we need to connect to.)
ip route 0.0.0.0 0.0.0.0 10.0.16.55 (firewall)
___________________________________________________________
Firewall/Proxy has the following:
route add 10.46.0.0 mask 255.255.255.0 10.0.30.31
____________________________________________________________
I know these route are correct, cause if I take off the 10.46.0.0 255.255.255.0 10.177.0.2 route and do a tracert route from my PC it will hit the firewall then hit the 4503 and then bounce back to the firewall.
____________________________________________________________
Now, heres the problem I have.
When I plug the router in to 4503, the line protocol comes up and line is ready. If I do a sh int status g3/24 it shows connected.
but I cannot pass any traffic through the line. (keep in mind that our parent company owns this and nothing except WWW is allowed through it, so I am not even able to ping the ethernet card on the router.
I have tried everyhting I can think of plus some more creative ideas, all have failed. But if I go back to the PC and hook the T1back into it I can pass traffic.
I know that they are not filtering by mac-address cause I can swap out NIC cards in the win2k box and still get there.
Am I missing somthing?
Like I have said I tried everything I can think of, Clear ARP on 4503 and unplug the 2600 for a minute to clear that ARP table. tried no cdp on the g3/24
The only difference I can see between the PC and the 4503 is the PC has a default gateway to the router. The 4503 has a route staement since its not the default gateway. From what I have worked with routing, route statements should do the trick. Never seen one where it didnt work, unless it was the wrong route.
Any ideas, please let me know.
Thanks
Anthony
04-24-2003 11:17 AM
Two things you might check. One check the ip address of the corporate router as it may have been mistyped. Second thing to check is the firewall to make sure that there are no filters set up to not allow any HTTP traffic. Last resort try another port on the switch.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide