5505

[leo.vaughn]

How can I check CPU utilization on 5505, not the RSM module but the switch side of it? I am running ver. 4.5. I am sorry I could not find it on Cisco's web site.

Thanks,

[bsivasub]

Ps -c

Remember it shows the utilization in reverse.

5505(enable) ps -c

CPU usage information:

Name CPU-Usage Invocations

--------------- --------- -----------

Kernel and Idle 97% 0

Flash MIB Updat 0% 165

runTimeDiag 0% 101

SynDiags 0% 4954

SynConfig 0% 36545334

In this case, it is 3 % utilized.

[leo.vaughn]

How did you get 3%? Is it 100%-97%?

Thanks,

[bsivasub]

yes sir :)

[leo.vaughn]

I am sorry for another question. Where did find this command? I've looked everywhere on Cisco's website and I couldn't find it.

Thanks again,

[bsivasub]

Well, this command is replaced with a generic "show processor cpu" in later codes (5.x)

It is mentioned in this URL

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sft_6_1/cmd_ref/sl_w_cmd.htm#xtocid1050316

but i don't see much documentation for it. I work in TAC and so I had used it before.