6509 MSFC2 minor hardware problem

[s.uslay]

Can anyone shed a light on this problem? Everything seems fine but getting the following error...

thanks

Serhat

Minor hardware problem in Module # 15

Use 'show test 15' to see results of tests.

2005 Jan 05 15:02:41 %SYS-1-MOD_MINORFAIL:Minor problem in module 15

2005 Jan 05 15:02:41 %SYS-4-NVLOG:SYNDIAGS:Minor hardware problem in Module #15. Use 'show test 15' to see results of tests.

2005 Jan 05 15:02:42 %SYS-5-MOD_OK:Module 15(WS-F6K-MSFC2,SAL08342RQ8) is online

Console> (enable) sh test 15

Diagnostic mode: minimal (mode at next reset: minimal)

Module 15 : 1-port Multilayer Switch Feature Card

Line Card Firmware Status for Module 15 : PASS

Port Status :

Ports 1

--------

.

Line Card Diag Status for Module 15 (. = Pass, F = Fail, N = N/A)

Loopback Status [Reported by Module 2] :

Ports 1

--------

F

[glen.grant]

You should set it up for complete diagnostics and when you get a chance reboot the switch and see what it says . Currently it is set as minmal diags and doesn't test much when booting up .

[s.uslay]

I have rebooted the switch few times and did not see any problem even a minor one..

thanks

Serhat