Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
394
Views
0
Helpful
3
Replies

802.1q & dlsw

antpezga
Level 1
Level 1

‎03-16-2006 05:06 AM - edited ‎03-03-2019 02:18 AM

The following configuration is possible?. DLSW between a 802.1q subinterface and an Ethernet interface.

Thanks

interface FastEthernet0/0.1

encapsulation dot1Q 300

ip address x.x.x.x x.x.x.x

no ip redirects

ip nat outside

bridge-group 1

dlsw local-peer peer-id x.x.x.x cost 1 promiscuous

dlsw icannotreach sap F1

dlsw bridge-group 1

dlsw udp-disable

bridge 1 protocol ieee

Labels:
0 Helpful
3 Replies 3

Prashanth Krishnappa
Cisco Employee
Cisco Employee

‎03-16-2006 05:22 AM

What IOS are you running? It should work in newer IOS. Support for this was added through the following bug

http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCdv26715

0 Helpful

antpezga
Level 1
Level 1
In response to Prashanth Krishnappa

‎03-16-2006 05:24 AM

IOS (tm) 3600 Software (C3640-JK8S-M), Version 12.2(15)T17, RELEASE SOFTWARE (fc1)

0 Helpful

Prashanth Krishnappa
Cisco Employee
Cisco Employee
In response to antpezga

‎03-16-2006 05:50 AM

Your IOS should support it.

0 Helpful
Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card