09-20-2006 08:13 AM - edited 03-03-2019 05:08 AM
hello netpro:
i increate a int vlan x in sw3550emi ,I have no configure,but the int vlan x show it's mtu 1501.who can tell me what's the problem? thank you
sw1#sh int vlan 5
Vlan5 is up, line protocol is up
Hardware is EtherSVI, address is 0013.1ab4.fe00 (bia 0013.1ab4.fe00)
MTU 1501 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
sw1#sh run int vlan 5
interface Vlan5
no ip address
end
sh version
IOS (tm) C3550 Software (C3550-I5Q3L2-M), Version 12.1(20)EA1, RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Wed 04-Feb-04 23:28 by yenanh
Image text-base: 0x00003000, data-base: 0x00827298
ROM: Bootstrap program is C3550 boot loader
sw1 uptime is 5 minutes
System returned to ROM by power-on
System image file is "flash:/c3550-i5q3l2-mz.121-20.EA1.bin"
cisco WS-C3550-24 (PowerPC) processor (revision P0) with 65526K/8192K bytes of m
emory.
Processor board ID CAT0819X0FZ
Last reset from warm-reset
Bridging software.
Running Layer2/3 Switching Image
09-20-2006 08:33 AM
I'm not sure if there is a problem becuase a standard Ethernet frame MTU is 1500 bytes. This does not include the Ethernet header and Cyclic Redundancy Check (CRC) trailer, which is 18 bytes in length, to make the total Ethernet frame size of 1518.
09-20-2006 06:57 PM
thank u for your attention.
I can't understand that the default mtu is 1500 but why there is 1501 .
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide