Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, In the WLC there are two groups (say A and B). How would I take group B and point it to a RADIUS server for authentication please? Looking for a step by step answe please. The server is ping reachable. I have seached but did not see any di...
Hi, Unique? Load DistributionI have a requirement to use EIGRP to route over two paths using ratios. The actual question is more complicated but I'll try and keep the question uncomplicated. The primary requirement is to use a ratio for all traffic,...
Hi Robert,
I work with Sleiman.
Per your request:
HQ_APIC01# acidiag verifyapicopenssl_check: certificate detailssubject= CN=FCH2017V01S,serialNumber=PID:APIC-SERVER-M2 SN:FCH2017V01Sissuer= CN=Cisco Manufacturing CA,O=Cisco SystemsnotBefore=May 6...
I should add that the RADIUS box's IP is in the WLC. I guess I'm just looking for how to make group "B" go through the RADIUS server for authentication please.
If you have a large, stable network OSPF can do well but EIGRP is slightly easier to configure and handles default routes quite nicely.Good IP planning is critical either way.HTH, please rate
