I am trying to upload the embedded ciscoview to my catalyst 4006 (SUPII+). for some reason I keep getting the following information when I try to install the software.
Cat001#archive tar /xtract tftp://x.x.x.x/Cat4000IOS.v9-0.tar bootflash:cv
Extract directory bootflash:cv is not present
So I thought ahah! I'll just create the cv directory, well when I do that I get this..
Cat001#mkdir
Translating "mkdir"...domain server (x.x.x.x) (x.x.x.x)
% Unknown command or computer name, or unable to find computer address
shouldn't mkdir be a valid command? Here is my show version..
Cat001#show version
Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I9S-M), Version 12.2(25)EW, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2004 by Cisco Systems, Inc.
Compiled Fri 10-Dec-04 14:26 by kellythw
ROM: 12.1(20r)EW1
Dagobah Revision 95, Swamp Revision 3
Cat001 uptime is 1 day, 14 hours, 58 minutes
System returned to ROM by reload
System restarted at 00:07:19 UTC Tue Jan 11 2005
System image file is "bootflash:cat4000-i9s-mz.122-25.EW.bin"
cisco WS-C4006 (MPC8245) processor (revision 4) with 262144K bytes of memory.
Processor board ID FOX050210260
MPC8245 CPU at 266Mhz, Supervisor II+
Last reset from Reload
1 Virtual Ethernet interface
48 FastEthernet interfaces
74 Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.
Configuration register is 0x2102
Any help would be appreciated.
Adam T
