AS 5300 and multiple dial-up to one account.

[lwahlers]

We are an ISP - one of our products include the setup of "One dial-up account for multiple users". This is to cater for large groups looking for a cheaper rate.

With the analogue dial-up we do not have a problem at all, but with the ISDN connections the AS tries to bundle the calls causing the second connection to time-out.

Thus on that one account any amount of analogue can connect but only one ISDN (64/128) connection is possible.

Is there a way around this?

Do I configure the AS or the Radius Server?

Thank you.

[makchitale]

We can use the various options available under the "ppp ipcp xxxxxxxx"

such as ppp ipcp address unique / ppp ipcp ignore-map/ ppp ipcp username unique.

If you do not need "ppp multilink" for isdn users, remove it. But if you need it then the bundles should be formed based on endpoint descriminator (not username)...."ppp multilink endpoint xxxxxx"

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122tcr/122tdr/drfmupp.htm#1134174

Also on the Radius enable multiple simultaneous login.

Thanks, Mak.

[lwahlers]

Thank you Mak,

will give it a go.

Lutz