03-06-2003 09:44 PM - edited 03-02-2019 05:39 AM
I am having problems when i assign an ip address to the eth0.1 subinterface,
this is what its showing me-
Configuring IP routing on a LAN subinterface is only allowed if that subinterface is already configured as part of an IEEE 802.10, IEEE 802.1Q or ISL vLAN
when i am typing show ip interface eth0.1, this is what it shows me -
IP processing disabled.
Could anyone guide me?
03-06-2003 10:00 PM
This should answer your question:
03-07-2003 10:16 PM
You need to configure the subinterface for VLAN trunking encapsulation first.
Example:
int e0.1
encapsulation dot1q (or isl) vlan#
after that, you can assign an IP address, etc.
If this is not a trunk link, then use the ip address x.x.x.x y.y.y.y secondary command on the main interface to multinet the interface.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide