06-14-2002 08:06 PM - edited 03-01-2019 10:12 PM
How do I stop the AT commands to stop coming out of the console port? I can get into the diagnostic console to reset factory defaults, and reset console port to defaults, but when it continues boot up, it goes back to throwing AT commands on my screen. Any help?
Operation firmware version: 5.35
Boot firmware version: 2.04
06-15-2002 04:23 AM
Some older models of 2800/1900 switch require a null modem cable, while others require a regular rollover cable. If you use the wrong cable you will get AT commands at the prompt
Regards,
-Prashanth
09-11-2002 11:56 AM
You have wrong cable pinout. Make sure that you have pinout like on
Figure A-6 of the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/lan/28201900/1928v5x/icg5x/csspec.htm#xtocid115097
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide