ATM IMA problem on 3825 router

[kope]

I am upgrading the router hardware from a 3620 to a 3825 router. I am running ATM IMA with 4 T1 bundle. The existing router (3620) has been running fine, but when I switch to the new router 3825, I can't bring up the ATM interfaces (the 4 T1). But when i switch back to the old router, it works fine.

The config basically is identical between the two.

I am puzzle what went wrong. is the ATM service provider need to do anything on their end?

Any suggestion on this would be greatly appreciated.

[Roberto Salazar]

Check the clocking if they are configured.

network-clock-participate

network-clock-select

Please rate all posts.

[kope]

I configured this as follows:

network-clock-participate wic 0

network-clock-participate wic 1

network-clock-participate wic 2

network-clock-participate aim 0

network-clock-select 1 T1 0/0/0

network-clock-select 2 T1 0/0/1

network-clock-select 3 T1 0/1/0

network-clock-select 4 T1 0/1/1

[kope]

it turns out to be the service provider has to re-provision their circuit on their ATM switches. After that, all works well.

Thanks all your help.