Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone has the GLC-SX-MM transceiver works on a ASR-1002x Gigabit fiber SFP port?I searched Cisco web site and it says ASR1002x supports GLC-SX-MMD only. Just like to see if it actually would work on GLC-SX-MM as well.
I noticed my IME has about 6290 signatures available; but I also notices there are only about 3500 signatures enabled; others are not checked.I believed they are by default for a brand new IPS. Do anyone know why the rest half of those signatures are...
I understand the ASA sip inspection is enabled by default on its service policy. Can I disabled it and not causing any problem?I noticed the ASA does has sip session transit through it.ciscoasa(config)# policy-map global_policy
ciscoasa(config-pmap)...
i have two asa runnig 8.4 configured as Active/StandbyNow i received a new Anyconnect license, how do i install the new license?- Install the activation key on the Active and Standby unit.- Install the activation key on the Active unit only.which one...
I was looking for redundancy, not load sharing; and if static (default) routes suffice here.yes, there is a switch between the routers and the ASAs, so they can be on the same subnet. Looks like I need to configure some sort of ip SLA if i am using d...
Hi Sam,I also tried as below, but return with an INFO message...ASA1(config)# logging message 106100 level 3INFO: Please use the access-list command to change the severity level of this syslogASA1(config)#Any idea...thank you
logging list APR27_2011 level errorslogging list APR27_2011 message 106100logging buffered APR27_2011 I have this setup as above and it still did not showed any message id 106100; it just shown error level messages.Is there anything wrong here?thanks...
ok, i noticed the Alternate Greeting for the "After Greeting" is "take a message".I think this should be point to a Call Handler instead. Right?The call flow is supposed people dial to this extension, leave a message, and automatically transfer/forwa...
