04-26-2004 12:37 PM - edited 03-02-2019 03:16 PM
I have a dedicated full T1 between two campuses and I need to configure my 2610's with T1 WIC's. I would like to test this in a LAB environment before deploying the routers. Can you help?
04-26-2004 01:50 PM
You can make a crossover cable and connect them. For a t1 crossover you need 4 wires.
1 -> 4
2 -> 5
4 -> 1
5 -> 2
04-27-2004 05:40 AM
The Cisco article I read said I could use the Cisco Roll-over cable. Is this true? I still don't get a green CD light when I use a flat roll-over. If I connect it directly to the T1 coming in the CD light goes green.Thanks for your time.
04-26-2004 03:10 PM
You can follow the instructions inthe following URL. It should be pretty much the same even if this one is for the 2522:
Hope this helps,
04-27-2004 07:53 AM
Does this document reside in any other area besides partners? I don't have access to the partners CCO area of Cisco. Can you email me the HTML? john.riffle@watkins.com, thanks in advance for your help....John
05-06-2004 03:58 AM
John,
If you take the "partner" part out of the URL, you can get to the document Harold Ritter referenced. Here's a revised link:
http://www.cisco.com/en/US/products/hw/routers/ps233/products_tech_note09186a00800a3f09.shtml
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide