cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
309
Views
0
Helpful
2
Replies

Back to back connection for WIC-1DSU-T1-V2

jjia
Level 2
Level 2

Hi,

I have two 2621XM routers with each WIC-1DSU-T1-V2 card. I wonder if I can have a back to back connection with the two routers. And which kind of cable if it can. Which configuration should I use on the interfaces?

Thanks,

JJ

2 Replies 2

thisisshanky
Level 11
Level 11

Yes,

Make a T1 cross over cable. Cross pin 1 to 4 and 2 to 5. You will need a crimping tool for making this cable.

Configure one end of the 2621 with clock source as internal while the other 2621 should be configured with clock source as line.

Hope that helps!

Sankar Nair
UC Solutions Architect
Pacific Northwest | CDW
CCIE Collaboration #17135 Emeritus

Thanks.

Review Cisco Networking for a $25 gift card