04-04-2004 11:59 PM - edited 03-02-2019 02:47 PM
Got two routers and want to use the AUX ports via back-to-back with a "rolled cable". I have followed this page ( http://www.cisco.com/warp/public/793/access_dial/auxback.html ) to a T but I can not get RIP ver.2 to go over the AUX ports. Does anyone have any Ideas to make this work?
Plz be as detailed as possible. Thanks in advance!
04-05-2004 12:04 PM
As with any troubleshooting, we need to begin at the bottom. I would suggest the following:
- Verify the rollover cable is good. Hopefully it it not homemade. A breakout box or some other sort of cable tester should verify this. If that works:
- Reconnect the cable and make sure a noshut is done on both routers aux interfaces. If that works:
- Verify you are using the same version or RIP on both routers. RIP version I does not work with RIP version II. Either make both routers run ver. 1 or ver. 2. Since I did not see the RIP configs., I would also verify RIP is routing for the network you have set on both routers. I am sure you have this done already, but I thought I would throw it in anyway.
Hope this helps.
04-05-2004 03:00 PM
can you post your config
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide