I am running VOIP over FR. wHEN I set FR fragmenting to an appropriate size for low speed serial links I can not get to Public HTTP locations which are sending DF bit.
How can I configure AS5300 T1 to support CAS and fxo-loop-start signalling . Is this possible.I am going to connect my T1 port to a T1 Channel Bank to work with Analog Telephone Lines.
Is it possible to define traffic shaping policies based on either the source/destination IP Address? Can this be implemented on Layer 3 Switch/Routers as well? If so, how?
A client of ours wants to know if they can allocate bandwidth by application without the expense of router upgrades or the installation od packets shapers. Their network is a mixture of 1600, 2500 and 4000 series routers. From my investigation it loo...
I want to be sure the ISDN drops when the frame comes up, not just when it sees no traffic across the ISDN interface. 6 sites with 1750s/BRI/Frame FT1 and a 3640/PRI/Frame T1. I'm using OSPF, static floating routes and dialer maps to trigger the IS...
During disaster recovery testing we were using a full PRI connection (30 B channels). We found that when a third line was opened the data stopped going across the connection and the connection timed out. We eventually found that the problem was relat...
I have build a etherchannel between Cat 5500 and 3524 XL switch. Channel works fine, but when I want to tear down the channel at 5500, the channel configuration will not go away. I turned the mode to auto...as defined on CCO, to see if the channel br...
A 2651 with IOS 12.2(1a) is keeping isdn history for ever. Only rebooting clear that table.I have upgraded the router to "flash:c2600-jk9o3s-mz.122-1.bin"and still the same.
I have 10 cisco 3524 switches with ios verion on IOS (tm) C3500XL Software (C3500XL-C3H2S-M), Version 12.0(5.2)XU,I have download the reqired software for cisco site (jave plugin) which has mentioned on the switch manual (desktop switching configurat...
When I use dialer profile, and config ip ospf demand-circuit, the ospf doesn't suppress the hello on this interface. The IOS support the ip ospf demand-circuit command under the dialer profile or not.
