Boot Variable editing on 6500 Native
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-07-2005 09:41 AM - edited 03-03-2019 01:03 AM
Hello,
I have a 6500 running in native mode. When in rommon I noticed that the boot variables file is extremely congested, full of failed attempts at commands, etc. I'd like to clean up the file in order to reduce confusion if anybody else needs it. Where does the file exist for this (I have two supervisor 2 modules running).
Thanks,
John
- Labels:
-
Other Networking

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-07-2005 11:13 PM
Hi
are you talking about the boot sequence of the IOS code ?
if thats the case you can alter the boot system command in ur config.
always remove the boot command pointing unavailable files in ur flash disk and keep only one boot command pointing the latest ios code.
if you want to correct something else then do post out the o/p of the same and throw some lite on that requirement..
regds
