Hello,I have a 6500 running in native mode. When in rommon I noticed that the boot variables file is extremely congested, full of failed attempts at commands, etc. I'd like to clean up the file in order to reduce confusion if anybody else needs it. W...
Hello,I have a 6500 in native mode with dual sup2 modules. How can I switch between the active and standby supervisor mod/msfc? I am in a lab now, and can do this by reloading, but I know there must be a better way.Thanks in advance,John
Experienced a power loss while remotely uploading a new configuration to a WS-C2924-XL (running IOS 12.0(5)WC8). I am unable to authenticate since the device reloaded.I know that part of the config was successfully uploaded because I am being prompte...
Details on "redundancy force-switchover" can be found at:http://www.cisco.com/en/US/partner/products/hw/switches/ps708/products_configuration_guide_chapter09186a00800da705.html
Thanks many bthekkek.You wouldn't happen to have a URL for any documentation on this would you? This command gets me where I want to be, but I'd like to know more about it. Thanks again,John
PS If I would have scheduled a reload before doing the config I never would have had this problem. It's always easy to cancel a reload once the maintenance is complete...John
Thanks for the reply, Milan.I agree with you that only part of the config made it to the switch. Part that didn't make it included the ip address for the tacacs+ server so the switch cannot authenticate with anybody other than the backup username/pas...
