06-23-2004 12:39 AM - edited 03-02-2019 04:33 PM
Hello,
Talking about Catalyst 4006 Supervisor II with CatOS 6.4(8)...
After a power failure the switch didn't function at all. The status leds are red... And when resetting it from the console I got:
rommon 1 >reset
0:00.581381: ig0: 00:06:53:84:36:fe is 10.10.10.100
0:00.582243: netmask: 255.255.255.0
0:00.582664: broadcast: 10.10.10.255
0:00.583082: gateway: 10.10.10.10
WS-X4013 bootrom version 5.4(1), built on 2000.02.17 18:28:09
H/W Revisions: Crumb: 5 Rancor: 8 Board: 2
Supervisor MAC addresses: 00:06:53:84:33:00 through 00:06:53:84:36:ff (1024 addr
esses)
Installed memory: 64 MB
Testing LEDs.... done!
rommon 1 >
I performed the recovery procedure mentioned in:
"Recovering Catalyst Switches Running CatOS from Booting Failures"
http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a00800949c3.shtml
but with the same result!!!!
Any Suggestions, please
Thanx
YAS
06-23-2004 10:11 AM
you didn't mentioned what happened after you enter boot (filename) the attribute seems to be correct and it should work, I have done a lot in my envirment and it has worked for me.
Make sure that your computer is connected with the management port via cat5 cable and then you are able to ping the switch from pc and vise versa, also make sure that TFTP is up and running and you are typing the correct file name. if that still fails then you need to use xmodem.
06-23-2004 10:01 PM
Hello,
Thanx for replying...
The procedure I did was the same you mentioned. In fact when I issue the boot command I could see the percentage indication in the TFTP server window.
And I got the same above-mentioned result as booting from the switch...
Would you provide more info about Xmodem?
Thanx
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide