cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
565
Views
0
Helpful
4
Replies

Cannot ping from one room to another (Packet Tracer)

tp068713
Level 1
Level 1
 

2022-08-18 (2).png

Hello, so as you can see, I am able to ping from one device to another as long as they are within the same room/have the same NWID. I am a beginner at setting these network diagrams up and I was sure I followed all of my teacher's instructions. Is there a reason why I am unable from ping from one room to the next? 

 

Please do let me know which amendments I have to make.

4 Replies 4

make sure you enabled routing in connected main router

then configure related default gateway properly in PCs in each network

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB

Hello, 

 

This should mean that I've already enabled routing, right? I already had it on last night, which is why I was confused why it wouldn't work. Could you please tell me if there's a way to fix it?

2022-08-19.png

Hello,

post the zipped Packet Tracer project (.pkt) file...

Here, thank you so much!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco