07-10-2023 10:07 AM
Hello Everyone
I have an issue regarding to Cisco 892 router. I want to get into the rommon mode but I cant because it doesn't not react on break command.
Have you had that king of issue?
Thanks in advance
07-10-2023 10:16 AM
Hi @Irakli G.
It can be key board detail. Make sure you fall into one of this case or try them all.
Software | Platform | Operating System | Try This |
---|---|---|---|
Hyperterminal | IBM Compatible | Windows XP | Ctrl-Break |
Hyperterminal | IBM Compatible | Windows 2000 | Ctrl-Break |
Hyperterminal | IBM Compatible | Windows 98 | Ctrl-Break |
Hyperterminal (version 595160) | IBM Compatible | Windows 95 | Ctrl-F6-Break |
Kermit | Sun Workstation | UNIX | Ctrl-\l |
Ctrl-\b | |||
MicroPhone Pro | IBM Compatible | Windows | Ctrl-Break |
Minicom | IBM Compatible | Linux | Ctrl-a f |
ProComm Plus | IBM Compatible | DOS or Windows | Alt-b |
SecureCRT | IBM Compatible | Windows | Ctrl-Break |
Telix | IBM Compatible | DOS | Ctrl-End |
Telnet | N/A | N/A | Ctrl-], then type send brk |
Telnet to Cisco | IBM Compatible | N/A | Ctrl-] |
Teraterm | IBM Compatible | Windows | Alt-b |
Terminal | IBM Compatible | Windows | Break |
Ctrl-Break | |||
Tip | Sun Workstation | UNIX | Ctrl-], then Break or Ctrl-c |
~# | |||
VT 100 Emulation | Data General | N/A | F16 |
Windows NT | IBM Compatible | Windows | Break-F5 |
Shift-F5 | |||
Shift-6 Shift-4 Shift-b (^$B) | |||
Z-TERMINAL | Mac | Apple | Command-b |
N/A | Break-Out Box | N/A | Connect pin 2 (X-mit) to +V for half a second |
Cisco to aux port | N/A | Control-Shft-6, then b | |
IBM Compatible | N/A | Ctrl-Break |
07-10-2023 10:36 AM
07-10-2023 10:49 AM
Yes, you should be alerted if the command were used.
I dont believe the device will not respond to break what might be hapanning is the key sequence is not getting right to the device.
Did you try those combination I shared ?
07-10-2023 11:00 AM
07-10-2023 11:10 AM
Sure it is. Not all cisco device expect for Breat as boot interruption.
07-10-2023 11:22 AM
07-12-2023 03:13 AM
What's the config-reg setting?
07-26-2023 03:27 AM
Hello, it was cable problem, I used CH340 USB To RS232 DB9 Serial Port Converter Cable.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide