Hi All, We have upgraded our existing on prem SSM to the latest version so he supports CLSU as well. We have adapted our switches with the clsu configuration. If I login to my SSM I can see all the switches under inventory - licenses. Under the tab "...
Forum Posts
I have to regenerate HTTPS certificates on some ISR IOS-XE (17.6.3a) WAN routers. We're using WAAS Central Manager (6.4.5c b32), which I believe communicates with the AppNav routers via HTTPS. Once the certificate is updated, is there are process req...
Is there a tool available for making these transitions less time consuming?Will a cut and paste of configs (with some image/system specific manual changes)?Will we have to reconfigure everything from scratch?
Hi everyone I have problems configuring a subscription with grpc on the catalys 3650 switch.Software version:Cisco IOS XE Software, Version 16.06.03Configuration:telemetry ietf subscription 10encoding encode-kvgpbfilter xpath /interfaces-ios-xe-oper:...
I have a couple of buildings located remotely that I am wanting to secure.If I put the buildings in non-routed vlans, how will they access Internet resources?There are servers in those buildings that people on the internet need access to, will puttin...
Resolved! Time synchronization via Broadcast
HelloI have questions about the ntp broadcast (server) <--> ntp broadcast client.In my scenario is:On router R1 (NTP server on 1841 router) the ntp broadcast is active on Fa8 (trunk port).On SW1 (Catalyst 2960) the ntp broadcast client is on Fa0/13 (...
I can ping router to router but not PC to router/PC. the packet tracer lab is attached. thank you in advance!
Resolved! ASA Lab
Have been working on other vendor's firewalls for many years. But will find myself supporting an ASA soon. Some issues I'm seeing on getting familiar with this platform are:1. dCloud doesn't have anything that will run logged in with my cco/certifi...
Hi In VxLAN configuation. some of them are differenct with normal. for example, the below two PC do not need to configure default gateway. Its fine because both PC think they are in the same subnet and send traffic through a tunnel between two VTEP. ...
Resolved! Connection Issue in VXLAN
Hi Please see the below VXLAN diagram. The only issue is VTEP01 and VTEP02 can not see nve peers each other via command show nve peers and PC01 cannot ping PC02. VTEP01 and VTEP02 can ping each other, and all show ip mroute 239.1.1.1, and show nvee i...
Hi, i am doing my project on packet tracer. I am using Router 2901 version 15.5(3)M4a. I am trying to activate the license securityk9 so that I am able to configure point to point VPN. However, after i reload the router, and saving configuration afte...
HiI have a problem that I`m unable to find a solution for and was hoping someone could help me.The protocol in play:SAIA SBUS IP UDP port 5050. A PLC to PLC communication protocol that implement a “guarantied” transmission: more information 26-776_EN...
Hi,I've added the CSR1000v node simulation to CML2-PE and learning the RESTCONF via Python requests package.The current target is to change one of the configured ACL port action from permit to deny.The RESTCONF GETheaders = {'Content-Type': 'applicat...
Prepare a topology with 3 locations(1 for the center and 2 for the branch).For each location; i)Identify 2/24 networks,assign different vlan-id for each network. ii)Identify 1core 2 acsess Switches and 4 PC’s. iii)Det...
What is the main purpose of grounding the chassis of Cisco equipment that come with a ground point and lug?
