cat 4006 port

[ctopp]

I have a cat 4006 with 48 ports enabled. How can I find what ports that been used by workstations.

[jgross]

Hi

If you enter a show port command at a CatOS Switch, there is a column named status. If there is connected, there is an end station active at this port. If there is notconnectd, there is no active end station at the port.

There is no posssibility to fing out if there is an not active (switched off) End station at the port. If the end station is switched off, port is notconnect.

If you have IOS do a show ip interface brief

Bye

Jo

[ctopp]

Thanks I know that. You know you can use the ifindex for each port to find infomation but I forgot how.

Carlos