Router A-----Leased line-----outside#Router B(NAT)#inside | |-----Leased line-----outside#Router C(NAT)#insidei have two static nat router(cisco 7206) with same public&private ip address for redundancy and load balancing.(it is not connec...
I need to know the design best practices for using a L2 Core vs L3 core because of excessive peering from the IGP. If OSPF and EIGRP have different recommendations please include.Thank you!!John
I just installed CiscoWorks LMS 2.2 and RWAN 1.3 on two different Windows 2000 servers. Since the Common Services CDs are the same for the both, why is it that I see "ANI Server Admin" under Server Configuration for LMS, but not under Server Configur...
We are migrating our IP design from 192.168 to 10.2 networking. I would like to make the transition seamless while supporting both networks at the same time. Can I support 2 networks on the same vlan?int vlan 101ip address 192.168.1.1 255.255.255.0...
We have an older RSP7000 with an EIP board. We use an AUI to RJ45 Transceiver to connect to a CISCO 5505 switch. The switch port is auto detected at 10bt half duplex. The router also has an ESCON Channel Interface (CIP) Approx. 144mb/sec . During an ...
When the switch with spanning tree root guard deteces its neighbor switch become the root for one of the vlans, will it block the whole port or just the vlan only?thanks
Hi All, i have 5500 switch in which we are using cat ios and fan tray is failing now and then i want o find the part number and serial number for the fan tray... For native ios the command is there i.e show idprom fan-tray but cat ios i coul...
I'm trying to setup GLBP across two transparent switches and two routers so if one goes down I have redundancy with the others, currently each router has a trunk to each switch. Do I also need to create a trunk between the two switches for GLBP to fu...
Hi Experts. Customer wants to buy a dark fiber connection between their 2 sites and connect 2 Cisco 7200 w/ PA-A3-OC3SMI back-to-back. Would a configuration without an ATM network service in between be possible? If so, do I need to disable ilmi or so...
I have been searching in the MIB of a 2610 router, because I need to generate some Concord graphics on the connection to the provider. In fact, it is a router on our premises, but not available to log in. However, what I see is that with 'public' as ...
We have a network of four routers which, when an ISDN line is activated, form a physical loop. I.e. each router connects to two others. Two of the routers are Cisco 2600 and the other two are Cisco 7206. The ISDN connects a Cisco 7206 > Cisco 2600A f...
hi,i configured the following on a 3725 router with 12.2.8T5:policy-map rrw_512 class rrw_gold bandwidth percent 30 class rrw_silber bandwidth percent 30 class rrw_stahl bandwidth percent 30 class class-default fair-queue!policy-map btu-w...
Is there a way to enable snmp traps for atm pvcs on a Cisco router?The "snmp-server enable traps" command doesn't give you that option. Any suggestions?
