CAT6509 & MSFC

[fcatalao]

While doing an upgrade to sup1A MSFC I founf that I could not session to 15.

I´m pretty sure that I mest up with the boot variables.

How can I access the MSFC (rommon) and fix this?

Thanks

[fcatalao]

Never mind I found a document to do this. Can I configure HSRP between two Cisco 6000, where one has SUP1A PFC/MSFC2 and the other SUP1A PFC/MSFC?

[Prashanth Krishnappa]

The following document should help

http://www.cisco.com/warp/public/473/124.html

Let me know how it goes

[fcatalao]

Thank you, but I had already found that document.

What I need to know is if I can configure HSRP between 2 6000, where on has SUP1A PFC MSFC and the other SUP1A PFC MSFC/2?

Thanks

[Prashanth Krishnappa]

Yes..You sure can

[fcatalao]

I apologise for only getting back to you now, but I got busy with other stuff.

In the abovementioned document it mentions that, if MSFC's ROMmon is still not accessible then to power off and remove the MSFC. I´ve done that but still cannot access ROMmon. For the location of the MSFC, in the document "http://www.cisco.com/warp/public/473/124.html"

points to the back of the supervisor and the document "http://www.cisco.com/warp/customer/108/hwts_msfc_18000.html"

it points to the middle. What next?