09-11-2006 09:11 PM - edited 03-03-2019 04:58 AM
G'day,
I'm trying to get PBR working for a specific interface (gi x/x) rather than a whole vlan.
I know this is possible on other platforms but i'm kinda stuck :(
Current version is....
12.2(18)SXF4
Any tips would be great!
Thanks
Andrew
Solved! Go to Solution.
09-12-2006 10:53 PM
Yes, minimize the ACL will also lower the router's resource to process the ACL. i.e. hit the rule earlier.
09-11-2006 09:35 PM
What I suggest if you have the hardware on hand, just try to enter the config, if it accept then there should be no problem.
If it can't, you may configure a dedicated VLAN for the GE then PBR to this VLAN is the same. You cannot PBR traffic to a trunk and even you PBR to a physical interface, it should be in access mode.
Hope this helps.
09-11-2006 10:07 PM
G'day,
It looks like I cant run it on a switchport :-( ...
It is currently setup via a vlan but I would have like a little extra granularity with hosts would be PBR'd without using ACL's.
Ohh well, ACL's it is then!
Thanks Jack!
CHeers
Andrew
09-11-2006 11:14 PM
You're welcome. If the traffic will be PBR'ed then it should be using ACL, otherwise, how do you determine which traffic is require to redirect ? ;)
09-12-2006 10:49 PM
yeah, I only wanted a single acl for each "application (tcp any eq 80 any)" to minimise the amount of acls..
Ohh well... one acl for each server will have to do!!
09-12-2006 10:53 PM
Yes, minimize the ACL will also lower the router's resource to process the ACL. i.e. hit the rule earlier.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide