02-19-2003 08:27 AM - edited 03-02-2019 05:12 AM
This is the weirdest thing I have seen in awhile. I just purchased 3 2924XLs, new in box. But each switch does not have a base mac address(set to all zeros)
Is this possibly a diagnostic mode?
I would appreciate any help.
Jonathan Nantel
02-19-2003 11:50 AM
can you put sh interface output...
04-24-2003 01:34 AM
Try to take a look into the env_vars.
This can be done by SET command.
If there is no variable for MAC address, you can type it in by the SET command.
eg. SET MAC_ADDR nn:nn:nn:nn:nn:nn
The correct MAC address should be written on a lable attached at the back plane.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide