09-12-2006 05:47 AM - edited 03-03-2019 04:59 AM
I am replacing a 2950 and a 2600 with a 3750 Switch. where do I put the routing information? ex. RIP, EIGRP ect...
Thanks
DMan
09-12-2006 06:03 AM
Darnell,
The switch will come with an IOS similar to a router. The syntax will be the same, just make sure you enable routing by typing
ip routing
while in config mode.
09-13-2006 04:05 AM
Thanks!
09-12-2006 09:02 AM
Darnell,
Please refer the below URL for configuring RIP,OSPF,EIGRP,etc on the Catalyst 3750 Switches.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12225see/scg/swiprout.htm#wp1372733
I hope it helps.
Regards,
Arul
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide