Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
304
Views
0
Helpful
2
Replies

Catalyst 6348 module bad Toshiba chip

rtrowbr
Level 1
Level 1

‎07-01-2002 11:44 AM - edited ‎03-01-2019 11:18 PM

I have had multiple module failures of my 6348 mods across the campus that apparently have a bad chipset lot. Does DFM 1.1 have a specific instance or event that will notify me if traffic stops, even when all ports show connected via the console?

Labels:
0 Helpful
2 Replies 2

rmushtaq
Level 8
Level 8

‎07-01-2002 11:52 AM

I believe not. http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/dfm/dfm_faq.htm should clear up things for you. As a side not, DFM 1.2 is also now available.

0 Helpful

srkannan
Level 1
Level 1

‎07-01-2002 02:56 PM

NOt possible. these failures are not monitored and there are no specific event that corresponds to such failures. And when the traffic stops, DFM assumes that the it is within the threshold limit set and does not generate an alarm,

If there are any syslog messages generated co-relating to the component failures, then RME -> Syslog analyser will be a good place to check.

0 Helpful
Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card