cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
410
Views
0
Helpful
3
Replies

Catalyst4500 and EIGRP summary

gena1405
Level 1
Level 1

Hi!

I would be very grateful for explanation situation why in routing table i see

D* 0.0.0.0/0 [90/33280] via 10.15.0.2, 00:31:53, FastEthernet2/16

[90/33280] via 10.15.0.9, 00:31:53, FastEthernet2/14

but in topology table

P 0.0.0.0/0, 2 successors, FD is 33280

via 10.15.0.9 (33280/30720), FastEthernet2/14

via 10.15.0.2 (33280/30720), FastEthernet2/16

via Summary (28160/0), Null0

Why summary route is not FD?

Thanks

3 Replies 3

ruwhite
Level 7
Level 7

Coudl you post a show ip eigrp topo 0.0.0.0 0.0.0.0? We need to see the rest of the output. At this point it either looks like a summary-address statement with an admin distance attached to it, or something is wrong.

Thanks!

:-)

Russ.W

This one

Core1_MT#sh ip eigrp topology 0.0.0.0

IP-EIGRP (AS 1): Topology entry for 0.0.0.0/0

State is Passive, Query origin flag is 1, 2 Successor(s), FD is 33280

Routing Descriptor Blocks:

10.15.0.9 (FastEthernet2/14), from 10.15.0.9, Send flag is 0x0

Composite metric is (33280/30720), Route is Internal

Vector metric:

Minimum bandwidth is 100000 Kbit

Total delay is 300 microseconds

Reliability is 255/255

Load is 1/255

Minimum MTU is 1500

Hop count is 2

Exterior flag is set

10.15.0.2 (FastEthernet2/16), from 10.15.0.2, Send flag is 0x0

Composite metric is (33280/30720), Route is Internal

Vector metric:

Minimum bandwidth is 100000 Kbit

Total delay is 300 microseconds

Reliability is 255/255

Load is 1/255

Minimum MTU is 1500

Hop count is 2

Exterior flag is set

0.0.0.0 (Null0), from 0.0.0.0, Send flag is 0x0

Composite metric is (28160/0), Route is Internal

Vector metric:

Minimum bandwidth is 100000 Kbit

Total delay is 100 microseconds

Reliability is 255/255

Load is 1/255

Minimum MTU is 1500

Hop count is 0

Exterior flag is set

Core1_MT#

Can you open a TAC case on this? There are several defects in this area, but there's a lot more analysis that needs to be done (looking at the config, looking at the routing table, looking at the version number). If not, then post the version, the static routes configured, and the eigrp section of the configuration.

:-)

Russ.W

Review Cisco Networking for a $25 gift card