HIThe situation is :simplest configuration of net Pe---Pe2 pe routers 7603 - 3BXL connected each other ethernet connection through sm fibers During test in rack all is fine .when we install this PEs at distance 100 km ( GBIC CWDM ) we found strange...
The situation is ring from cat3550 with implementation of RSTP connected to 7600 (PE-routers) on both side Is it possible organized TE tunnel instead of L2tpv3which will be able to pass RSTP BPDU packets in order to connect virtual ring ?THX advance
Hi!I would be very grateful for explanation situation why in routing table i seeD* 0.0.0.0/0 [90/33280] via 10.15.0.2, 00:31:53, FastEthernet2/16 [90/33280] via 10.15.0.9, 00:31:53, FastEthernet2/14but in topology tableP 0.0.0.0/0, ...
Unfortunately Integrated Routing and Bridging is not supported on cBus platforms (AGS+ and Cisco 7000 series) and hence it's impossible make bridge -group virtual interface in router.But maybe another way will solve our problem if i make anoter con...
This one Core1_MT#sh ip eigrp topology 0.0.0.0IP-EIGRP (AS 1): Topology entry for 0.0.0.0/0 State is Passive, Query origin flag is 1, 2 Successor(s), FD is 33280 Routing Descriptor Blocks: 10.15.0.9 (FastEthernet2/14), from 10.15.0.9, Send flag is...
i try to emulate situation with management vlan : 3550---trunk802.1Q(vlan 800,700,900)-----4506 at 3550 4506 was entered all above mention command but i added only vlan 10 there is another vlans 800.700.900 on both switch and they vlan added to trun...