10-20-2004 05:32 PM - edited 03-02-2019 07:25 PM
I have tried to change the system password through the
I go through the whole procedure but it then states I have no authorization can someone help?
10-20-2004 06:42 PM
I am assuming this is a Catalyst 2970 switch. I just did a recovery in my lab with no issues. Can you email me the boot up sequence of you recovering the password? I want to make sure you are doing it right.
10-20-2004 07:45 PM
I got in now I have 8 vlans and no configuration on the system I want to learn how to reconfigure the vlan and understand how to configure the ports in auto or 10/100. I also like for it to use my ip on my server so all the systems can communicate throught this. my ip is 192.168.1.1 for my server. I also like to know if the rest of the manual to the switch can help me with that?
10-21-2004 05:16 AM
Say you want to configure VLAN2,3 and 4
2970(config)#vtp mode transparent
Setting device to VTP TRANSPARENT mode.
2970(config)#vlan 2
2970(config-vlan)#vlan 3
2970(config-vlan)#vlan 4
2970(config-vlan)#exit
Now say you want to assign gig 0/1 to VLAN 2, here is waht you would do
2970(config)#int gigabitEthernet 0/1
2970(config-if)#switchport mode access
2970(config-if)#switchport access vlan 2
Here is how you configure speed/duplex
2970(config)#int gigabitEthernet 0/2
2970(config-if)#spe
2970(config-if)#speed ?
10 Force 10 Mbps operation
100 Force 100 Mbps operation
1000 Force 1000 Mbps operation
auto Enable AUTO speed configuration
2970(config-if)#duplex ?
auto Enable AUTO duplex configuration
full Force full duplex operation
half Force half-duplex operation
You might also want to use the config guideline which will be very useful.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2970/12119ea1/2970scg/index.htm
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide