08-28-2004 09:40 AM - edited 03-02-2019 06:05 PM
While flashing a 678, during flash it seemed to lock and a red led is on inside the case. Router is now not accessible from Hyperterminal. Anyway to get it back into debug mode?
08-28-2004 12:45 PM
Hello,
check this link, scroll down to page 4 of the PDF document, it talks about the procedure to reset the 678 to factory defaults:
Cisco 678 Configuration
http://www.webguyinternet.com/dsl/CiscoSetup.pdf
HTH,
Georg
08-28-2004 12:56 PM
Thanks for the reply. We have tried this procedure. The red led light that is on is in the case on the circuit board. It is not the Alarm light. Most forums I have checked said this means the router is dead.
Is there any other procedure to try? Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide