Other Network Architecture Subjects

I have an issue that someone may be able to help with.We have a solution that uses a Cisco router to connect via 2 seperate PVC's to different locations for resilience. We use EIGRP and bandwidth statements to define which PVC to use as the primary.W...

Whats my best way for providing DHCP for a company having 1 server and several VLANS

what's the recommended way to create a LAN (same layer 2 segment) between 2 sites connected via PPTP T1?Thanks!

I have a multihomed network running BGP with 3 separate ISPs on a 3725 router. I have Public Address space (/24 net) that will be used for all internal hosts that need to be reachable from the public internet. But I also have several other internal...

Basic question: I have a 4006 switch with only a sup II engine. Can I use/enable vlans with this or do I need to upgrade to a sup III?

Dear All,Is is possible to run MPLS on a 6509 SUP1/MSFC2 running native IOS ?Will greatly appreciate any feedback.Regards,Zahid

Hi,I have server on which i want to install LMS for windows and the server has a RAID configured on it with the total available hard disk space of 130 GB.I want to know how should i partition my hard disk and which partion i should use for what.Regar...

My neighbor is installing a wireless connection to backup his leased line T1 circuit. The radio link will be connected to a SOHO6 firewall in the OPT port for the dual ISP connection. Is there any special config for the router to be able to route to ...

Does anyone know if the following patches are supported with LMS2.2 Update1? KB842526KB841872KB841873KB840315KB839645 KB867801 Thanks,Maretha

I have a 1760 router with a WIC-2AM and two Ethernet adapters. One Ethernet adapter is connected to my AD domain. Is there a command in the IOS that uses the AD to authenticate users who dial-in through the 2AM instead of having to set up user acco...

looking at deploying IP telephones. would like a list of 12 port switches that support Power over Ethernet, switches must also support multiple VLAN's

Hello everyone!I have a problem! I have 2 5006 switches, and I have lost the enable password for one of them. I have tried following one of the documents posted on this website, but I still can't get it!Any suggestions anyone?Btw, these switches ar...

I have a cisco AS5400. When I connect to the cisco over modem (without running ppp) it gives me immediately prompt "Username", it doesn't wait untill I press Enter as it was working on cisco AS5200. Does anyone know what to set to start it working?Pr...

Only layer2 VLAN packet with Cos value is avaliable for QoS queuing on Cisco catalyst 6509 switch,and layer 3 packet not, right?Who can help to explain it?Thanks.Mario