Cisco View - Configuration

srooplal · ‎12-17-2002

I recently installed LMS2.1 with Cisco View - the devices come up correctly (cat 4006 IOS and cat 6513 IOS) but I cannot configure any of the ports - example to add a name to a specific port - an error appears. This does not happen on the existing CWSI station. I have downloaded the latest packages for the 6513/4006 - both have IOS.

rmushtaq · ‎12-18-2002

What is the error message?

srooplal · ‎01-28-2003

Sorry about the delay - we still have the issue when modifying through CV - - when we cahnge a name for example , the following error appears -

"No such name error on PortName5.21".

Thanx

ydaigneault · ‎02-03-2003

Hi,

I have the same problem... Any solutions yet?

regards, Yves Daigneault

srooplal · ‎02-04-2003

No response from Cisco - according to one of the consultants it could be a bug on the cat 6513 - I have version c6sup22-dsv-mz.121-11b.Ex1.bin - I have cat 4006 with SUP III and it works fine - please advise if you have any response

YThanx

ydaigneault · ‎02-04-2003

Hi,

my bug shows up on a Catalyst 4006 - Sup II. I'll open a case and let you know...

regards, Yves.