11-19-2004 06:56 AM - edited 03-02-2019 08:04 PM
Hello
Have installed Cisco Works SNMS. Now we have two different kinds of Cat4500. One with a SupII and the other with SupIV.
Our customer would like to configure the vlans of a port on each devices. On the Cat4500 with SupII it works (CatOS). But on the Cat4500 with SupIV (IOS) it doesn't work.
Here the different software levels we have installed:
SupIV IOS 12.1(12c)EW2
Device Package Version 5.0 for Cat4000, Version 9.0 for Cat4000 IOS
Download Embedded CiscoView for Cat4000 IOS Version 9.0
Is this actually possible for a SupIV? If yes, any suggestions?
Erich
11-27-2004 01:42 PM
Check if CDOne is installed properly on this switch.
11-29-2004 05:17 AM
hello
thanks for your answer. but i don't understand what you exactly mean with cdone is installed properly on this switch.
cdone is the base module for cisco works and how should i be able to install this on a switch?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide