Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
583
Views
0
Helpful
5
Replies

CiscoWorks GUI session timeout

iswift
Level 1
Level 1

‎10-13-2003 03:27 AM - edited ‎03-02-2019 10:57 AM

Hi,

Anyone know the default value for a LMS session timeout befroe you get the 'Your login session has been terminated' message ?

Also if you can specify another value.

Have had a look round the product and tried searching the on-line documentation to no avail.

Ian Swift.

Labels:
0 Helpful
5 Replies 5

rmushtaq
Level 8
Level 8

‎10-13-2003 09:22 AM

By default it is 2hrs.

0 Helpful

iswift
Level 1
Level 1
In response to rmushtaq

‎10-14-2003 12:28 AM

Thankyou.

Is there a (supported) way of changing this ?

Ian.

0 Helpful

smasraum
Level 1
Level 1
In response to iswift

‎03-08-2004 06:29 AM

There is NOT a supported way of changing the value.

0 Helpful

guffe
Level 1
Level 1
In response to smasraum

‎03-08-2004 08:59 AM

What is the unsupportet way because i need it, and accept the issue about no support

0 Helpful

guffe
Level 1
Level 1
In response to rmushtaq

‎03-08-2004 03:18 AM

How do i change the 2 hours timeout on cw2k, because i have to make a Focal point console based on DFM and syslog where they display the status.

0 Helpful
Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card