Has anybody experienced slow response with the CNR GUI when connecting to a CNR server across WAN links? If I attempt to config a secondary zone on a remote CNR server I get a 2 minute delay opening the DNS@ns2.x.x, chosing Add, inserting a name and selecting secondary. The WAN has 20 ms latency across t1 links that are MT.
I have seen probs with cisco's mgt aps where they get pretty picky about calling by IP address or FQDN. FQDN makes a drastic improvement in PIX PDM. I have tried both ways in this CNR case.
Anybode else been there?
Regards
Richard