Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Working on deploying ACE active active with multiple contexts. Need to do some One Arm on top of L2 bridge as well. I have a L3 interface between the ACE and core router on vl90. The ACE has FT. Core has hsrp and this is my default route ...
Stuck on this one.The 877 has a 4 prot managed switch. How / where is the port security?Desired to lock 1 mac address to a switchport and admin down on exception.Thanks Lost in the documentation.
Q: I have a dmvpn to a spoke connected via dsl. presently I have route 0.0.0.0 0.0.0.0 via pppoe (dslam) This allows me to find the home end of the tunnel and bring the tunnel up. How do I tell the spoke router to route all traffic via the tunnel? I ...
Has anybody experienced slow response with the CNR GUI when connecting to a CNR server across WAN links? If I attempt to config a secondary zone on a remote CNR server I get a 2 minute delay opening the DNS@ns2.x.x, chosing Add, inserting a name and...
Hello, I am in need of some advise.Requirement for multiple low bandwidth VPn tunnels terminating on one IOS router, 3620. Need to apply rate limiting to individual vpns.I would like 4 tunnels from customer 1 to terminate on IP address XI would lik...
Since this is not a higher end catalyst with the switchport security-xxx commands available, I believe this work-around comes close to the requirement, exception admin down.config tInterface vlan1 arp authorized! disables dynamic learning arp address...
