config port security on 3548s

[jackleung]

I am wondering if there is an easier way for me to set port security on multiple ports at once than one at a time with 3548s. I know with 3550 you can use the "interface range" command to accomplish this from config mode.

I tried using the CNA which allows you to highlight multiple ports but there's a problem setting meximum address count over 1. I'm trying to limit them to 2 but it won't let me save if I choose any number higher than 1. However doing it fomr command line works...

[wong34539]

I think, its a limitation in the 3548's... as you had mentioned, this can be done in the Catalyst 3550 using the "interface range" command.