cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
300
Views
0
Helpful
1
Replies

Configure 6506 to L3!

netadmin
Level 1
Level 1

Hello! I was looking to convert a L2 6506 by adding a new MSFC to a L3 switch. I'm in the process of creating vlan's on the router module. Is there a guide/how to that I can use? My other 6509 is already a L3 with HSRP configured. Is HSRP required on the 6506 then? Thanks in advance!

1 Reply 1

Prashanth Krishnappa
Cisco Employee
Cisco Employee

The following page should help with MSFC2 installation. Note that MSFC1 cannot be installed in the field and hence assuming its an MSFC2

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/cfgnotes/78_10605.htm

For configurations, the following page should help

http://www.cisco.com/warp/public/473/75.html

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_7_6/confg_gd/routing.htm

Since you have 2 chassis with MSFCs, HSRP would make sense for layer 3 redundancy(not a requirement).