Hello,
I will be configuring a T3/E3 network module in a 3745 for frame relay soon. This will be the first time I have configured the T3 module. We will have multiple remote sites in this frame relay cloud. Could someone review my sample configuration for the T3 module and make any suggestions or improvements. Any help is appreciated.
Thanks!
card type t3 1
controller t3 1/0
framing {c-bit | m23}
!!!!Router will be in rack with network equipment
cablelength 10
clock source {internal | line}
exit
!
!
dsu mode {0 | 1 | 2 | 3 | 4}
!!!!Full T3 as I understand
dsu bandwidth 44210
exit
!
!
!Specifies the serial interface created on the controller.
interface serial 1/0
encapsulation frame-relay IETF
frame-relay lmi-type ansi
no shut
!
interface Serial1/0.1 point-to-point
description Remote office #1
ip address 10.200.100.253 255.255.255.252
frame-relay interface-dlci 100
!
interface Serial1/0.2 point-to-point
description Remote office #2
ip address 10.200.101.253 255.255.255.252
frame-relay interface-dlci 101
!
!
!