Configuring HP Openview Network Node Manager to recognize cisco traps

[alalli2002]

Good Day,

I am having troubles with NNM recognizing traps form cisco routers.

I have installed the following mibs already.

snmpv2-smi

snmpv2-tc

smpv2-mib

rfc1213

IF-mib rfc 2863

Cisco-If mib

Cisco-smi

cisco-products-mib

cisco-tc-mib

I think that i might need some additional mibs???

I would appreciate seeing someone elses list of mibs on NNM.

thanks

amanda

[rmushtaq]

What are these traps which are not being recoganized by HPOV?. You can use the SNMP Object Navigator Tool on CCO:

http://www.cisco.com/cgi-bin/Support/Mibbrowser/unity.pl to traslate any of the unknown traps and then load the MIBs accordingly. Also see:

http://www.cisco.com/warp/public/477/SNMP/mibs_9226.shtml

[minielsen]

Loading MIB's into NNM doesn't configure the event handling. At the best TRAP-TYPE's in the MIB's will be entered, but you need to finalize the configuration yourself. Information like severity and alarm text simple isn't available in the TRAP-TYPE.