connecting two 2501s using DDR

[tvorhauer]

I am trying to configure site "A" (2501) to dial site "B" (2501) using DDR. Site "B" has a FR circuit back to headquarters site "C", so that it can allow site "A" to access the FR circuit.

Does anyone have a sample config that I can look at. I am a little fuzzy on how to configure the aux ports, access lists, dialer/async intefaces, etc.

Thanks in Advance for any assistance.

[rsissons]

Try the Dial Access Cookbook at the following URL. It has many good examples -

http://www.cisco.com/warp/customer/793/access_dial/index.html