We have an cisco soho 91 at my office wich stopped responding when we got back to work one morning.
All leds on it was lit on the "lan side" (it has four lan ports) but it was not allowing any traffic to get through. After shutting the router on/off without positive effect I connected my pc to the console port and saw that the router was in rommon.
I did a reset and saw this:
rommon 1 > resetú
System Bootstrap, Version 12.2(8r)YN, RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 2002 by cisco Systems, Inc.
C800/SOHO series (Board ID: 28-130) platform with 32768 Kbytes of main memory
boot: cannot determine first file name on device "flash:"ú
System Bootstrap, Version 12.2(8r)YN, RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 2002 by cisco Systems, Inc.
C800/SOHO series (Board ID: 28-130) platform with 32768 Kbytes of main memory
boot: cannot determine first file name on device "flash:"
System Bootstrap, Version 12.2(8r)YN, RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 2002 by cisco Systems, Inc.
C800/SOHO series (Board ID: 28-130) platform with 32768 Kbytes of main memory
rommon 1 >
The result of "dir flash:":
rommon 1 > dir flash:
File size Checksum File name
5274944 bytes (0x507d40) 0x359e soho91-k9oy6-mz.123-2.XC.bin (bad checksum: 0xa3a3)
rommon 2 >
Does this mean that the bootfile is corrupt? Is the only way to fix this by downloading another bin? How could it happen?
Regards, Ronsta
I did a reset