10-18-2004 07:41 AM - edited 03-02-2019 07:21 PM
Helo,
I am confusing about the transport input and transport output command. Does anyone can describe to me?
I would like to configure dial-in remote access and not want to enable reverse telnet feature. What command should I use?
Thanks,
Nitass
10-18-2004 07:38 PM
hi
hope this link would be helpful to understand about transport input and output..
this one will be helpful to configuring remote dialin..
regds
10-19-2004 09:03 AM
Hi,
Thank you for your reply.
I understand transport input on line indicate which protocols can pass network interface on cisco box to connect to the line. Is it correct?
But for transport output, what direction is it applies?
Thanks,
Nitass
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide