Other Network Architecture Subjects

Hi all, can the FSIP serial or SSIP serial on 7507 support ip multicast well? I have config the multicast on 75's SSIP 2M serial, but the effect is bad, lost packets,and if I change the line and same config to the 4T serial on 3661, the multicast eff...

Hi,We are using a 3550-12G as our core Layer2/3 switch and also doing inter-vlan routing. Is it possible to get Netflow stats from this switch for Intra VLAN traffic as well as Inter VLAN traffic ?Following the usual netflow commands, i can only get ...

it looks it needs 256M dram to support gatekeeper. Is there any other version which supports gatekeeper with just 128M dram? thanks. just want to test this in the lab.

Hello,Could any one tell me the difference between RSP16 and RSP16=(spare)?Would there be any problem if the router only has RSP16=?Thank you

We are running NetFlow switching on many sites and links (serial, Frame) and it is all fine- 2 way traffic flows showing up great. Can't seem to get 2-way stats from ADSL lines though. I have tried putting the ip route-cache flow command on the diale...

Can anyone give me some feedback on which MIB might be used to manage UPS's via SNMP vis Ciscoworks?There is an RFC 1628 standard MIB for such a task, but it seems that Cisco doesn't support that MIB in it's own MIB file.The UPS manufacturer also has...

Hi,Does anyone know the command to find out the serial number of a 3640 router. I thought it was "show version" but that doesn't seem to have the serial number in there.Thanks,Ted

Hello,We have a Cisco 7200 router running v11.0x.When we attempt to download a bootstrap file from a TFTP server, which is located on a different subnet than the machine attempting to download the bootstrap file, we receive a TFTP timeout error.Howev...

Hi I have a problem with the Aging Time Timer.I have the following scenari:Two routers (7300 and 7500) and their are connect to two diferent Catalyst (6500 and 4006), The 7500 router is connect to 4006 and the 7300 is connect to 6500. And these Catal...

Hi , Here is a design scenario: Distribution 4605 4605 | | L3 L3 | | Core :--- 6509A sup720 --- ISL ---- sup720 6509A --------------- L3 Etherchannel ------ | | | | L3 L3 | | Distribution 4605 4605 I have 2 core switches connected to more than four 4...

Helo,I am confusing about the transport input and transport output command. Does anyone can describe to me?I would like to configure dial-in remote access and not want to enable reverse telnet feature. What command should I use?Thanks,Nitass

He tratado de que dos equipos: un servidor con Windows 2003 y un Switch Catalyst 4506 intercambien rutas mediante OSPF pero no lo he logrado, el 4506 tiene configuradas varias Vlan y el servidor en mencion pertenece a una de estas, en el visor de eve...

I have a 2600 router working on a T1 connection. I need to ensure that 1 of the gateways on the router has 64K of bandwidth dedicated to it at all times. GLBP load balancing & weighting does not seem feasible - I'm looking at the command "sync mode d...

Hi ,I am trying to set up an SVC between two routers that are connected back-to-back via ATM interfaces. When I set up the following configuration , I can see the signalling events in the debug output but I am not able to ping the interfaces. Is it p...